bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Winnebago Intent Motorhome


  • Troubleshooting Kwikee Steps Extending and Retracting During Travel When it Rains
  • If rain is causing the Kwikee Step assembly on your Winnebago to extend and retract that there is almost certainly something going on with the wiring that's causing a short. I know you said you already did this but I would still start by double and triple checking all the wiring for the control module and assembly to make sure there aren't any loose connections or pinched or exposed sections that need to be repaired/replaced. If all of this is good then there may be a crack or space somewhere...
    view full answer...

  • Troubleshooting a Kwikee Single Step That Will Not Fully Extend/Retract & Just Goes Back and Forth
  • We have encountered this problem before and it turns out it was the gear on the bottom of the steps starting to wear out, causing the step to bounce on the way in or out and not fully extend/retract. Since you have a single step, the correct gear would be the Replacement Gear for Lippert Single Step # LC301696. I do recommend checking that the gear is bad/worn out. If the gear looks to be in decent shape, it could potentially be the controller. It sounds like the switch is working out...
    view full answer...

  • Is Drilling Required to Install SumoSprings on 2018 Winnebago Sunstar 31BE
  • The correct SumoSprings Custom Helper Springs for your 2018 Winnebago Sunstar 31BE (that features an 18,000 pound GVWR), which is the part # SSF-170-40-2 for the front axle and # SSR-184-40-1 for the rear axle, will not require any drilling during installation. These are complete bolt-on applications that will simply replace the factory bump stops on the Ford F-53 chassis. I have attached a couple short video demonstrations along with the written installation manuals for these kits that...
    view full answer...

  • Replacement Awning for 2018 Winnebago Intent
  • If your 2018 Winnebago Intent is a 26M it would have came with a 19 foot awning or if it was a 30R it would have came with a 22 foot awning. For a 19 foot awning we have the complete kit Solera XL 12V power awning part # LCV000334966-362243 but the longest option we have is 21 foot with the part # LCV000335015-362241. These are both powered kits that draw power from the RV's 12 volt battery and have a 9-1/2 foot projection.
    view full answer...

  • Will SumoSprings Kit # SSR-184-40-1 Fit Motorhome with Sway Bar Installed
  • Yes, the SumoSprings kit part # SSR-184-40-1 will fit your motorhome that has a sway bar installed currently.
    view full answer...

  • Could Hitch-It Bike Rack for Trailer Tongues fit Tow Bar
  • Yes the Hitch-It 2 Bike Rack for Straight Tongue Trailers part # LC731138 would fit on the shank of a Blue Ox tow bar like you have.
    view full answer...

  • Recommended Sway Bars, Steering Stabilizer, and SumoSprings for a 2019 Winnebago Intent 26M
  • I have listed the parts you have requested for your 2019 Winnebago Intent 26M below along with any installation videos we may have. The steering stabilizer and sway bars will fit both the 16,000 lbs and 18,000 lbs models and the SumoSprings are confirmed to fit your 26M. Steer Stabilizer - Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets item # RM33RR Front Sway Bar - Roadmaster Front Anti-Sway Bar item # RM-1139-148 Rear Sway Bar - Roadmaster Rear Anti-Sway Bar item #...
    view full answer...

  • Recommended Suspension Enhancement and Steering Stabilization for 2021 Winnebago Intent 29 L
  • To reduce the bumps and smooth out the ride on your 2021 Winnebago Intent 29L on a Ford F-53 chassis I recommend adding SumoSprings. You will need the # SSF-173-40-2 for the front and # SSR-187-54-1 for the rear. These will absorb the bumps and road shock while also helping to minimize sway. They have a bolt-on installation and come with a lifetime warranty. For steering stabilization you need the Roadmaster Reflex Steering Stabilizer with Mounting Brackets # RM62VR. This will keep you...
    view full answer...

  • Propane T-Fitting with Quick Connect that can be Used After Propane Regulator
  • Technically you can use any T-fitting, including one like the MB Sturgis Sturgi-Stay T-Fitting for POL Valve # 103537-MBS before or after your propane regulator. The correct placement and T-fitting is going to depend on what you are trying to hook up. More often than not you are going to want your T-fitting before the regulator. You do not want your propane to be double regulated because it is going to cause you to not have enough gas pressure for your appliances to work properly. Basically...
    view full answer...

  • Correct Wiper Blades for 2018 Winnebago Intent
  • Yes, the Wiper Technologies Windshield Wiper Blade part # WPR47FR is a confirmed fit for a 2018 Winnebago Intent both passenger and driver side.
    view full answer...

  • Recommended Skid Wheels For A 2020 Winnebago Intent 29L
  • If your hitch cross bar is 2-1/2" x 2-1/2" then I recommend the Ultra-Fab Rotating, Hitch Mounted Skid Wheels for RVs up to 30' Long - 4" Diameter - Qty 2 Item # UF48-979014. It comes with a rotating wheel to allow you to make turns while the wheel is in use. The wheel is 4" in diameter to help give you a little bit more clearance. The 1/4" thick urethane layers of the outer edge of each wheel provide an anti-skid barrier and ensure that the wheel last even longer by avoiding metal degradation.
    view full answer...

  • Dimensions of Lippert 50 Foot Long Hand Reel for Power Cords
  • The Lippert Reel Away Short Covered Storage Reel with Hand Crank for 50' Long Power Cords # LC677583 is 17-3/8 inches long at the base and 13-1/2 inches wide without the handle. The handle adds 2-7/8 inches to the width for a total of 16-3/8 inches. The unit is 14 inches tall. I've attached a video to help.
    view full answer...

  • Does Blue Ox KarGard Towed Vehicle Protector Work in Crosswinds
  • The Blue Ox KarGard Towed Vehicle Protector # BX8870 will absolutely hold up in the Colorado crosswinds and there are a couple of reasons why. The first is that the KarGard is designed from what is called polyethylene, which is a thermoplastic that allows it to be flexible and thus more aerodynamic as you drive. The other reason is how securely it attaches to your tow bar. The KarGard # BX8870 secures to your tow bar with U-bolts and a locking rod that will keep it firmly in place. I...
    view full answer...